Tuesday, January 22, 2008

Loft Conversion Wiring, plumbing and the first floor board

A bit of a cheat counting the first floor board at this stage as I had to fit the wiring and plumbing under the floor first. But it was up there giving me a more stable platform to work off.



The Loft wiring was a simple ring for the sockets the lighting to go in walls later. Just because it would be neater in the long run and it seemed oportune I also wired TV coax to go the 1st floor bedrooms, down into the lounge and into the cellar.

The timeline drifts a bit here but I wasn't taking many photos. I must have done the plumbing for the radiator around this time. This came off the 15mm feed and return under the floor in the girls room (shifting stuff round in their bit to get at the floor is a job in it's self). From there it goes up the lathe and plaster stud wall, only one noggin so I only had to cut a small square out at the bottom of the wall and one in the middle .




It comes up about 300m from the radiator down pipes, so that plan came together quite nicely. After a wet test I took the rad back off. Just realised I must have built the stud wall by this time.





and so I had

Also by that time I'd taken down the airing cupboard, another couple of days covered soot and dust, not just me but the house and its contents.
With it out, the landing really opened up.




The flooring came up the stairs and the ladder then got laid. A bit of a no brain job putting it down apart from the tricky bits round the edge. I used, I think 14 sheets of 2 x 8 x 18mm Wickes best T and G chipboard. 300 screws latter ( I dont want a squeaky floor) it was down and giving me a more relaxing stance to start on the rest of the dividing wall and the insulation.

The wiring down to the cellar fuse board went up the underneath of the stairs wiggled across the landing and up the old stud wall along from where the plumbing went in. Conviently emerging close to where a fuse board for the attic has been fitted. Whilst the opportunity was there I also put in two telephone cables, the coax (I might use for DAB as I've lost radio 4 in the dinning room), and the cable for the downstairs smoke alarm.

Loft Conversion - Building control structural inspection

A moment of truth..... had I completed all the structural work on the steels, joists and purlin replacements to the required standards?

Of course I had, with total confidence I rang building control for an inspection, no problem with the next day service. However the inspector I was expecting had move areas so a the new chap wasn't familiar with the project and effort I'd put into the planning. Still no nerves, I was confident.

The very nice man came halfway up the ladder, had a look round and was impressed. What a good excuse for a beer that evening.
A few days latter the bill for the inspections came through, Unavoidable beurocratic expense. ho hum.

Loft Progress upto Jan 08

I've final got round to adding a bit more. I had set a deadline of Christmas to finish the room off ( building wise anyway). A pat on the back for myself because I did it. There's nothing like a deadline to get a job done.

Just the Stairs to make the room habitable and a few bits and bobs like electrics connecting and certifying, a door, decorating, flooring and blinds for the velux. Not take me two mins.

I had a couple of weeks off to tile the dining room fireplace and instal a log burning stove in time for christmas.

It's full steam ahead on the stairs with the center post machined and installed.

The next posts cover what ive been upto.