Finishing the Insulation

The next layer of insulation had to be fitted up to the battons on the rafters. This final 35mm layer of Kingspan TP10 over the top of the 75mm TP10 brings the total roof insulation up to 110mm . These were easy to fix up using long clout nails but again some very careful cutting required to get a good fit.


I also had to insulate the party and gable end walls. For this I used Kingspan Kooltherm Dry Lining board K17. This has 60mm of insulation with 12.5mm plaster board bonded to it. Heavy and awkward to get up there and cut being 8 x 4 sheets but it was relatively fast progress. I dab fixed in place with normal board adhesive





Showing the Insulated wallboard fitted aroung the chimney breast with a bit of skirty foam filling the gaps.